- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw list
- Cover
- PSU hinge
- Bezel
- Memory module
- Hard drive
- Optical drive
- Graphics card
- WLAN module and SMA antenna
- IO panel
- Power button module
- Speaker
- Intrusion switch
- Solid state drive
- Coin cell battery
- Power supply unit
- Front fan
- Top fan
- Heatsink assembly
- Voltage regulator heat sink
- Processor
- System board
- Troubleshooting
- Getting help and contacting Dell
- Optional IO card
- Cable cover
- Dust filter
- Chassis rubber feet
Precision 3640 Tower Service Manual
Removing the top fan
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the cover.
- Open the psu hinge.
About this task
The following images indicate the location of the top fan and provides a visual representation of the removal procedure.
Steps
- Disconnect the fan cable from the system board:
- Remove the single screw (#6-32) that secure the fan bracket to the chassis.
- Slide and remove the fan along with the bracket from the chassis.
- Pry and separate the fan from the fan bracket.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\