Precision Tower 3630 Cable Cover Installation Guide

The cable cover for Precision Tower 3630 helps protect ports and cables connected to the system.

1. Insert the tab on the security-lock metal bracket into the slot on the rear side of the system [1] and rotate to align the holes on the metal bracket with screw holders on the chassis [2]
2. Fasten the two #6-32x1/4'' screws to secure the security metal bracket to the chassis [3].
3. Pull the cable release latch and lift the latch away from the cable cover.
4. Lift the tab [1] to release and pull the cable tie from the slot on the cable release latch [2].
5. Align the cable release latch on the system chassis slot [1]. Tighten the screw to secure the cable release latch to the system chassis [2].
6. Route the cables through the slot of the cable cover [1], and connect them to their respective ports on the system [2]. Secure the cable with the cable tie and lock the tab in place [3].
   • CAUTION: Take care not to break or bend the delicate plastic hooks.
   
7. Align the plastic hooks of the cable cover to the slots on the system .
8. Gently press down on the cable cover until it clicks into place [1]. Slide the latch towards the chassis [2] to lock the cable cover in place.
   • NOTE: For added security, use the Padlock ring to secure the system.
9. To remove the cable cover:
   1. Slide the latch away from the chassis to unlock the cable cover [1].
   2. Lift the cable cover away from the system chassis [2].
10. Pull the cable cover to release it from the chassis.
11. Open the tab and unroute the cables from cable tie [1], disconnect the cables from the ports on the system [2]. Remove the cables from the slot of the cable cover [3].