- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- Recommended tools
- Screw List
- SMA antenna
- Side cover
- Top Cover
- Front bezel
- Hard-drive assembly
- WLAN card
- Speaker
- Fan assembly
- Memory modules
- Riser card
- Dell Ultra Speed Drive
- Graphics card
- External SMA antenna
- Solid-state drive
- Optional IO card
- Coin-cell battery
- Heat sink
- Interposer module
- Processor
- System board
- Internal antenna
- System board
- Internal antenna
- Troubleshooting
- Getting help and contacting Dell
Precision 3240 Compact Service Manual
Installing the graphics card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the graphics card and provides a visual representation of the installation procedure.
Steps
- Replace the graphics card into the slot on the riser card until it clicks into place.
- Close the expansion card latch and press it until it clicks into place.
Next steps
- Install the riser card.
- Install the
fan assembly.
NOTE This step is valid for system configuration that is shipped with 80 W CPU.
- Install the side cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\