Precision 7770 Service Manual

Removing the Compression Attached Memory (CAMM) module

NOTE:For models shipped with a CAMM module

The figure indicates the location of the CAMM module and provides a visual representation of the removal procedure.

Removing the CAMM module

Remove the two (M2x6) screws that secure the memory bracket on the CAMM module.
Remove the memory bracket.
Remove the two (M2x3.5) screws that secure the CAMM module to the system board.
Lift to remove the CAMM module and the CAMM connecter module from the system board.
CAUTION:When handling the memory connector DO NOT touch the pins on the connector module, the pins are fragile and any direct contact with the pins may damage them. Only hold the connector from the sides to avoid contact with the pins.