- Notes, cautions, and warnings
- Working on your computer
- Major components of your system
- Technology and components
- Disassembly and reassembly
- SD card
- SSD door
- Secondary M.2 solid-state drive
- Base cover
- Battery
- Solid State Drive
- Secondary memory module
- SIM card
- WLAN card
- WWAN card
- Keyboard lattice
- Keyboard
- Primary memory module
- Heat sink
- Power-adapter port
- Power button board
- Power button board with fingerprint reader
- Inner frame
- Smart-card reader
- Touchpad button
- SD card reader
- Power button
- Power button assembly with fingerprint reader
- GPU power cable
- System board
- GPU card
- Speaker
- Middle cap
- Display assembly
- Palm rest
- Display bezel
- Display panel
- Display hinges
- Camera
- P-sensor board
- Display cable
- Display back cover
- Troubleshooting
- Getting help
Precision 7750 Service Manual
Installing the power button board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
Steps
- Connect the power button board cable to the power button board.
- Align and place the power button board with power button cable into its slot on the computer.
- Replace the two (M2x3) screws to secure the power button board.
- Adhere the power button board cable to the palmrest.
- Connect the power button board cable to the connector on the system board.
Next steps
- Install the heat-sink assembly.
- Install the battery.
- Install the base cover.
- Install the SD card.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\