Precision 7680 Service Manual

Installing the long Compression Attached Memory (CAMM) module

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE:For models shipped with a long CAMM module

The figure indicates the location of the long CAMM module and provides a visual representation of the installation procedure.

Installing the CAMM module

Place the CAMM module into its slot on the system board.
CAUTION:When handling the memory connector DO NOT touch the pins on the connector module, the pins are fragile and any direct contact with the pins may damage them. Only hold the connector from the sides to avoid contact with the pins.
Replace the four (M2x3.5) screws to secure the CAMM module to the system board.
Place the memory bracket and replace the two (M2x6) screws to secure it to the CAMM module.