- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 7680
- Base cover
- Battery
- Battery cable
- SIM card
- Compression Attached Memory (CAMM) module
- Memory modules
- Memory interposer board
- WLAN card
- Wireless Wide Area Network (WWAN) card
- Solid State Drive
- Secondary M.2 solid-state drive
- Heat sink
- GPU card
- GPU power cable
- Power button board
- Power button
- Speakers
- Inner frame
- SD card reader
- SD card reader FPC
- System board
- Coin-cell battery
- Display assembly
- Power-adapter port
- Smart-card reader
- Keyboard
- Palm rest
- Drivers and downloads
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Precision 7680 Service Manual
Removing the power button board
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the base cover.
- Remove the heat-sink for integrated graphics or heat-sink for discrete graphics.
About this task
Steps
- Disconnect the power button board flexible flat cable (FFC) from the connector on the system board.
- Peel the power button board FFC from the system chassis.
- Remove the (M2x3) screw that secures the power button board to the computer.
- Remove the power button board with the power button board FFC from the computer.
- Disconnect the power button board FFC from the power button board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\