- Notes, cautions, and warnings
- Views of Dell Precision 5680
- Set up your Dell Precision 5680
- Specifications of Dell Precision 5680
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Camera
- Haptics trackpad
- Power adapter
- Battery
- Display
- Fingerprint reader
- Sensor
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell Optimizer
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Base cover
- Solid-state drive
- VPU card
- Battery
- System fan
- Heat sink
- Display assembly
- SD-card reader daughterboard
- USH and SD-card reader daughterboard
- Smart-card reader
- GPU card
- Dummy GPU card
- System board
- Speakers
- Haptics trackpad FPC
- SD card reader daughterboard FPC
- USH and SD card reader daughterboard FPC
- Wireless Local Area Network (WLAN) Antennas
- Power button with fingerprint reader assembly
- Palm-rest assembly
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Dell Precision 5680 Owner's Manual
Removing the battery
Prerequisites
- Follow the procedure in
Before working inside your computer.
NOTE:Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your computer.
- Remove the SD card.
- Remove the base cover.
NOTE: If battery was disconnected from system board for service, there will be a delay during system boot-up as the system will undergo RTC battery reset.
About this task
CAUTION:The information in this removal section is intended for authorized service technicians only.
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Steps
- Remove the six (M2x4) screws that secure the battery to the plam-rest assembly.
- Lift the battery away from the computer.
- Peel off the battery FPC cable from the battery.
- Disconnect and remove the battery FPC cable from the connector on the battery.
NOTE:Pull the pull tab vertically to disconnect the battery FPC cable.NOTE:When system battery is disconnected or completely discharged, the system date and time will be reset. When the system is power on under this condition, it will take slightly more time before the Dell logo is displayed, followed by the Time-of-day not set message. Select BIOS-Setup in the caution screen to configure the date and time.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\