- Notes, cautions, and warnings
- Views of Dell Precision 5680
- Set up your Dell Precision 5680
- Specifications of Dell Precision 5680
- Dimensions and weight
- Processor
- Chipset
- Operating system
- Memory
- External ports
- Internal slots
- Wireless module
- Audio
- Storage
- Media-card reader
- Keyboard
- Camera
- Haptics trackpad
- Power adapter
- Battery
- Display
- Fingerprint reader
- Sensor
- GPU—Integrated
- GPU—Discrete
- Multiple display support matrix
- Hardware security
- Smart-card reader
- Operating and storage environment
- Dell Optimizer
- Color, material, and finish
- Working inside your computer
- Removing and installing Customer Replaceable Units (CRUs)
- Removing and installing Field Replaceable Units (FRUs)
- Base cover
- Solid-state drive
- VPU card
- Battery
- System fan
- Heat sink
- Display assembly
- SD-card reader daughterboard
- USH and SD-card reader daughterboard
- Smart-card reader
- GPU card
- Dummy GPU card
- System board
- Speakers
- Haptics trackpad FPC
- SD card reader daughterboard FPC
- USH and SD card reader daughterboard FPC
- Wireless Local Area Network (WLAN) Antennas
- Power button with fingerprint reader assembly
- Palm-rest assembly
- Software
- BIOS Setup
- Troubleshooting
- Handling swollen rechargeable Li-ion batteries
- Locate the Service Tag or Express Service Code of your Dell computer
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Dell Precision 5680 Owner's Manual
Installing the smart-card reader
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
CAUTION:The information in this installation section is intended for authorized service technicians only.
NOTE:The following procedure is applicable for systems shipped with a smart-card reader only.
The following image indicates the location of the smart-card reader and provides a visual representation of the installation procedure.
Steps
- Align and place the smart-card reader with the smart-card reader FFC into the slot on the chassis.
- Replace the two (M1.6x1.7) screws to secure the smart-card reader to the chassis.
- Adhere the smart-card reader FFC on the palm-rest assembly.
- Connect the smart-card reader FFC cable to the connector on the USH and SD card reader daugherboard.
- Align and place the left speaker into the slot on the chassis.
- Replace the two (M1.6x1.8) screws to secure the left speaker in place.
Next steps
- Install the Battery.
- Install the base cover.
- Install the SD card.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\