Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Precision 7550 Service Manual

Installing the camera

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The figure indicates the camera and provides a visual representation of the installation procedure.

Installing the camera

Steps

  1. Place the camera module in its slot on the display back cover.
  2. Place the camera shutter cap on the top edge of the camera shutter.
  3. Connect the display cable to the camera module.
  4. Adhere the adhesive tape to cover the camera module.

Next steps

  1. Install the display panel.
  2. Install the display bezel.
  3. Install the speaker.
  4. Install the display assembly.
  5. Install the system board.
  6. Install the GPU card.
  7. Install the GPU power cable.
  8. Install the inner frame.
  9. Install the heat-sink assembly.
  10. Install the primary memory.
  11. Install the keyboard.
  12. Install the keyboard lattice.
  13. Install the WLAN card.
  14. Install the WWAN card.
  15. Install the secondary memory.
  16. Install the SIM card.
  17. Install the primary M.2 SSD.
  18. Install the battery.
  19. Install the base cover.
  20. Install the secondary M.2 SSD.
  21. Install the SSD door.
  22. Install the SD card.
  23. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\