- Notes, cautions, and warnings
- Working on your computer
- Technology and components
- Removing and installing components
- Recommended tools
- Screw size list
- SD card
- Base cover
- Battery
- Hard drive
- Hard drive interposer board
- Keyboard lattice and Keyboard
- Memory modules
- WWAN card
- WLAN card
- Solid State Drive
- Coin-cell battery
- Power connector port
- Palm rest
- Touchpad button
- SIM card
- Smart card cage
- Speaker
- LED board
- Heat sink assembly
- Graphics card
- System board
- Display assembly
- Display bezel
- Display hinges
- Display panel
- Camera
- eDP cable
- Display bracket
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Enhanced Pre-Boot System Assessment — ePSA diagnostics
- Built-in self-test (BIST)
- Diagnostic LED
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Battery status LED
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help
Dell Precision 7530 Service Manual
Removing the smart card cage
- Follow the procedure in Before working inside your computer.
- Remove the:
- To remove power switch board:
- Disconnect the smart card cage cable from the connector on the palmrest board [1].
- Pry the smart card cage cable.
- Remove the 2 (M2.0X3.0) screws that secure the smart card cage to the palmrest [3].
- Remove the smart card cage from the palmrest [4].
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\