NOTE Your computer’s Service Tag is located under the system badge flap.
You must enter the Service Tag in the BIOS after you replace the system
board.
NOTE Before disconnecting the cables from the system board, note the location
of the connectors so that you can re-connect them correctly after
you replace the system board.
To remove the system board:
Lift the latch and disconnect the touchpad cable [1].
Lift the latch and disconnect the keyboard controller board cable [2].
Disconnect the power connector port cable from the system board [3].
Disconnect the speaker cable from the connector from the system board [4].
Peel the adhesive tape and lift the latch to remove the fingerprint cable [5]
Lift the plastic lever and disconnect the display touchscreen cable [6]
Peel the adhesive tape to release the touch screen cable.
Perform the following steps to remove the system
board from the chassis:
Remove the M2x4 (4) screws that secure
the system board to the computer [1].
Lift the system board from the computer [2].
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\