Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell FluidFS NAS Solutions Administrator's Guide

Removing And Replacing The NAS Cluster Solution Controller

To remove and replace the NAS cluster solution controller:
  1. Label all the cables correctly before disconnecting any cables.
  2. Disconnect all cables from the back of the controller.
  3. Remove the failed controller from the appliance chassis.
  4. Install the new controller in the appliance chassis.
  5. Connect all cables to the new controller.
    • NOTE: For more information on removing and installing the controller, see the Dell FluidFS NAS Solution Owner's Manual, at dell.com/support/manuals.
  6. Ensure that the cables are reconnected to the same ports when installing the controller.
  7. Turn ON the new system by inserting the power cable.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\