Dell PowerVault ME5 Series Storage System CLI Reference Guide

show ipv6-network-parameters


Description	Shows the IPv6 settings and health of each controller module's network port.
Minimum role	monitor
Syntax	show ipv6-network-parameters [controller a\|b\|both]
Parameters	controller a\|b\|both Optional. Specifies whether to show addresses for controller A, controller B, or both. If this parameter is omitted, information is shown for both controllers.
Output	Firewall Enabled: A network firewall is active. Disabled: A network firewall is not currently active. Autoconfig enabled: Uses an IPv6 address computed by SLAAC or assigned by a DHCPv6 server, depending on the network configuration. disabled: Uses static IPv6 addresses set with the add ipv6-address command. Gateway The network port gateway IPv6 address. Link-Local Address The link-local IPv6 address. DHCPv6 Shown if Autoconfig is enabled. The IP address assigned by a DHCPv6 server. SLAAC IP Address Shown if Autoconfig is enabled. The IP address computed by SLAAC. IPv6 Address (1-4) Shown if Autoconfig is disabled. Shows between one and four manually set IPv6 addresses. IPv6 Label (1-4) Shown if Autoconfig is disabled. Shows the user-defined name, if set, for each manual IPv6 address.
Examples	Show IPv6 network parameters for each controller module. # show ipv6-network-parameters
Basetypes	ipv6-network-parameters status
See also	set ipv6-network-parameters