Dell PowerVault ME5 Series Storage System CLI Reference Guide

PDF

show alerts


Description	Shows information about the active alerts on the storage system. NOTE:The system presents a maximum of 512 alerts that are either unresolved, or resolved but unacknowledged. If further alerts are detected, resolved alerts are deleted to generate active alerts. If all 512 alerts are active, no new alerts are generated.
Minimum role	monitor
Syntax	show alerts [component <component-name>\|<component-type>] [unresolved\|resolved\|acknowledged\|unacknowledged] [detail]
Parameters	component <component-name>\|<component-type> Optional. Shows active alerts for a specific component name or type. A valid name is any value shown by the Component property in the command output. A valid type is any of the following values: controller, disk, drawer, drawer_slot, enclosure, expander, fan, fan_control_ module, fan_module, firmware_info, host_port, iom, mgmt_port, midplane, peer_connections, power_supply, sas_port, sensor, sideplane, slot, storage_pool, super_cap, system. unresolved\|resolved\|acknowledged\|unacknowledged Optional. Shows only alerts with the specified status. detail Optional. Shows the time each active alert was detected and resolved.
Output	ID The alert sequence number. Component The component name. Severity CRITICAL: A failure occurred that may cause a controller to shut down. Correct the problem immediately. ERROR: A failure occurred that may affect data integrity or system stability. Correct the problem as soon as possible. WARNING: A problem occurred that may affect system stability but not data integrity. Evaluate the problem and correct it if necessary. INFORMATIONAL: A configuration or state change occurred, or a problem occurred that the system corrected. No action is required. Resolved Shows whether the alert is resolved. Acknowledged Shows whether the alert has been acknowledged. Time Detected Shown by the detail parameter. The most recent date and time when the alert condition was detected. Time Resolved Shown by the detail parameter. If Resolved is Yes, the date and time when the alert condition was resolved. Reason A message describing the alert condition. Recommended Action The recommended action to take to resolve the alert condition.
Examples	Show active alerts. # show alerts Show active alerts for a specific component. # show alerts component controller_a Show resolved alerts for sensor components. # show alerts resolved component sensor Show detailed information about unresolved alerts. # show alerts unresolved detail
Basetypes	alerts status
See also	clear alerts set alert show alert-condition-history