Dell PowerVault ME5 Series Storage System CLI Reference Guide

Settings changed by restore defaults

This appendix summarizes the system settings that result from using the restore defaults command.

Table 1. Settings changed by restore defaults
Setting	Value
System information settings: System name System contact System location System information	Settings: Uninitialized Name Uninitialized Contact Uninitialized Location Uninitialized Info
Management protocols settings: CLI/Telnet CLI/SSH SLP FTP SFTP SNMP WBI/HTTP WBI/HTTPS Debug Ciphers setting	Settings: Disabled Enabled Enabled Disabled Enabled Disabled Disabled Enabled Disabled Default cipher strings
Users	All configured users are deleted and replaced with default user definitions and default settings: User: setup; Password: press Enter
CLI session timeout	Preserved
Tasks and schedules	Preserved
Time/date and NTP settings	Preserved
Network IP settings	Preserved
IPv6 network settings	Preserved
DNS management hostname	Preserved
DNS name servers	Preserved
DNS search domains	Preserved
SNMP settings: SNMP trap notification level SNMP trap host IPs SNMP read community SNMP write community	Settings: none 0.0.0.0 public private
SMTP settings: Email notification Email notify filter Email addresses Email server Email domain Email sender Log destination Include logs Alert notification Proxy setting	Settings: Disabled none none none none none none Disabled All Cleared
LDAP LDAP parameters LDAP settings User groups Audit log	Settings: Cleared Disabled (server IP defaulted to 0.0.0.0) Preserved Preserved
Syslog Sylog parameters Syslog settings	Settings: Cleared Disabled (host IP defaulted to 0.0.0.0)
Alert condition history	Preserved
Alerts	Preserved
SSL/SSH certificates	preserved
Disk group metadata	preserved
Host port settings: FC link speed FC topology	Settings: Auto Point-to-point
Host names and profiles	(preserved)
Disk spin down	Disabled
Advanced settings: Disk group background scrub Disk group background scrub interval Partner firmware upgrade Utility priority SMART Dynamic spare configuration Enclosure polling rate Host control of caching Sync cache mode Missing LUN response Controller failure Supercap failure Power supply failure Fan failure Temperature exceeded Partner notify Auto write back Inactive drive spin down Inactive drive spin down delay Disk background scrub Managed logs Single controller mode Auto stall recovery Restart on CAPI fail	Settings: Enabled 360 hours Enabled High Enabled Enabled 5 seconds Immediate Disabled Not Ready Disabled Enabled Disabled Disabled Disabled Disabled Enabled Disabled 15 minutes Disabled Disabled Disabled Enabled (for failover/failback, not I/O) Enabled
FDE settings	preserved
Replication sets Peer connections Replication sets CHAP records	Settings: Preserved Preserved Preserved
Enclosure settings: Name Location Rack number Rack position	Settings: cleared cleared 0 0
Host groups	(preserved)
iSCSI port settings: IP IP version Netmask Gateway Router (IPv6 only)	Settings: preserved preserved preserved preserved preserved)
Other iSCSI settings: CHAP enabled iSNS Jumbo frames	Settings: preserved preserved preserved
Host and initiator nicknames and profiles	preserved
Host groups	preserved
Host port mode	preserved
Volume identifying information	preserved
Volume groups	preserved
Pool settings: Thresholds Overcommit Limits and policy Snapshot space thresholds	Settings: preserved preserved preserved preserved
CLI parameters	CLI parameters are kept on a per-user basis. All configured users are deleted and replaced with default user definitions and default settings as detailed in the Users section of this table.
Debug log parameters	Each parameter is reset to its default as documented for the set debug-log-parameters CLI command.
Volume snapshot retention priority	preserved
Volume cache settings	Preserved
Expander PHY settings	Controller module root expander PHY settings are cleared
Volume tier affinity	preserved
Device identification LED status	preserved

Welcome

Welcome to Dell

Dell PowerVault ME5 Series Storage System CLI Reference Guide

Settings changed by restore defaults

Rate this content