Viewing information about volumes for each disk group in a pool
To see information about disk groups in a pool, in a Pool table expand the Disk Groups row.
For each disk group, the Disk Groups table shows this basic information:
Name
Controller (owning controller)
Level (disk-protection level)
Health
Number of disks
Size
Job (type and percent of progress)
In the disk group slide-over panel, the Overview tab shows this information:
The progress of any current job on the disk group
Disk group name
Serial number
Chunk size
Owner (preferred and current)
Sector format
Creation date
Minimum disk size
Active disk spin down:
Size
Free
Protection level
Number of disks
Target spare capacity (ADAPT)
Actual spare capacity (ADAPT)
Status
Stripe width ADAPT (16+2 or 8+2 options)
In the disk group slide-over panel, the Disks tab shows information about each disk. Disk location is shown in the format
<enclosure-number>.<disk-slot-number>.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\