Choosing
Add Data Protection opens the Data Protection Configuration wizard where you are led through the process of adding data protection to a selected volume by either creating local snapshots or creating a remote replication set.
The options that display in the wizard are dependent upon how the wizard is accessed:
Provisioning > Volumes >
menu list
> Add Data Protection
Provisioning > Volumes > Data Protection > Add Data Protection
Provisioning > Volumes >
slide-over >
Snapshots
Provisioning > Volumes >
slide-over >
Replications—Follow the on-screen directions to complete the action.
NOTE: When creating a remote replication or local snapshots, you will be prompted to set a schedule. This is the only place where you can set either a replication or snapshot schedule using the
PowerVault Manager. If you do not set a schedule when prompted, you will be unable to do so using the
PowerVault Manager after the replication set or snapshot is created. For information about creating a schedule using the
create schedule CLI command, see the CLI Reference Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\