Click
in the Current Peer Connections section of the panel to delete a peer connection if there are no replication sets that belong to the peer connection. If there are replications sets that belong to the peer connection, you must delete them before you can delete the peer connection
NOTE:If the peer connection is down and there is no communication between the primary and secondary systems, use the
local-only
parameter of the
delete replication-set CLI command to delete the replication set.
NOTE:If CHAP is enabled on one system within a peer connection, be sure that CHAP is configured properly on the corresponding peer system before initiating this operation. For more information about configuring CHAP, see
CHAP and replication.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\