Identify the FC WWNs and set up switch zoning
Record the FC HBA WWNs on the System Information Worksheet and set up switch zoning as requried.
Steps
-
Identify and record FC HBA WWNs:
-
Open a Windows PowerShell console.
-
Type
Get-InitiatorPort and press Enter.
-
Locate and record the FC HBA WWNs. The WWNs are needed to map volumes to the hosts.
-
If the hosts are connected to the storage system using FC switches, implement zoning to isolate traffic for each HBA:
NOTE Skip this step if hosts are directly connected to the storage system.
-
Use the FC switch management interface to create a zone for each server HBA. Each zone must contain only one HBA WWN and all the storage port WWNs.
-
Repeat for each FC switch.
NOTE The
ME5 Series storage systems support single initiator/multiple target zones.
Data is not available for the Topic