- Notes, cautions, and warnings
- Before you begin
- Mount the enclosures in the rack
- Connect to the management network
- Cable host servers to the storage system
- Cabling considerations
- Connecting the enclosure to hosts
- Host connection
- Connect power cables and power on the storage system
- Perform system and storage setup
- Setting up hosts
- Host system requirements
- Windows hosts
- Configuring a Windows host with FC HBAs
- Configuring a Windows host with iSCSI network adapters
- Prerequisites
- Assign IP addresses for each network adapter connecting to the iSCSI network
- Install MPIO on the host
- Configure the iSCSI Initiator on the Windows host
- Create a host and attach volumes in PowerVault Manager
- Enable MPIO for the volumes on the Windows host
- Format volumes on a Windows host
- Update the iSCSI initiator on the Windows host
- Configuring a Windows host with SAS HBAs
- Linux hosts
- Configuring a Linux host with FC HBAs
- Configuring a Linux host with iSCSI network adapters
- Configuring a SAS host server for Linux
- VMware ESXi hosts
- Citrix XenServer hosts
- Configuring a Fibre Channel host server for Citrix XenServer
- Configuring an iSCSI host server for Citrix XenServer
- Prerequisites
- Identify iSCSI adapters on a XenServer
- Configure a software iSCSI adapter on a XenServer host
- Configure the iSCSI IQN on a XenServer host
- Enable Multipathing on a XenServer
- Create a host and attach volumes in PowerVault Manager
- Create a Storage Repository for a volume on a XenServer host with a software iSCSI adapter
- Configuring a SAS host for Citrix XenServer
- Troubleshooting and problem solving
- Cabling for replication
- SFP transceiver for FC/iSCSI ports
- System Information Worksheet
- Setting network port IP addresses using the CLI port
- Technical specifications
Dell PowerVault ME5 Series Storage System Deployment Guide
Enable multipathing on an ESXi host
Use the vSphere Client to perform the following steps to enable multipathing on the ESXi host.
Steps
- Log in to the vSphere Client, and then select the new datastore.
- Select the Configure tab and click Connectivity and Multipathing.
- Select the host to use for multipathing.
- Under Multipathing Policies click Actions and select Edit Multipathing.
- In the Edit Multipathing Policies window, select Round Robin (VMware) from the Path selection policy drop-down list.
- Click OK.
-
Repeat this process for each volume that is presented from the
ME5 Series Storage system to ESXi host.
NOTE For detailed steps and custom commands for MPIO see the Dell PowerVault ME5 Series: VMware vSphere Best Practices guide.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\