Connect each FC port on the controller to a switch that is connected to the host ports as shown in the cabling diagram examples. You can also connect the storage system directly to the host server.
Connect to either a 16 Gb or 32 Gb host from the 32 Gb FC controller by using the applicable transceiver. Match the transceiver to your host/cable speed:
For 16 Gb connections—use a FC SFP transceiver
For 32 Gb connections—use a FC SFP+ transceiver
Use multi-mode OM3 or OM4 cables of the appropriate speed and length up to the following maximum:
OM3—100 meters
OM4—150 meters
For FC, each initiator must be zoned with a single host port or multiple host ports only (single initiator, multi-target of the same kind).
For information about configuring FC HBAs, see the FC topics under
Setting up hosts.
In addition to providing a host connection, these cables can be used for connecting two storage systems through a switch to facilitate use of the optional replication feature. See
Cabling for replication.
See the
Dell PowerVault
ME5 Series Storage System Support Matrix for supported Fibre Channel HBAs.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\