Table 1. List hard disk drive slotsThis table shows the parameters that is used to list the hard disk drive slots.
Parameter
Description
-a
Specifies the adapter used for the command. This can be either SAS WWID or AdapterIndex.
-enc
Specifies the enclosure used for the command. This is either WWN or EnclIndex.
-h
Provides more information about the command, description, and usage.
-outputformat
You can specify the following output formats: XML or JSON.
list drive slots -a=1 -enc=500a123456789012
list drive slots -a=1 -enc=0
list drive slots -enc=500a123456789012 -outputformat=xml
list drive slots -a=1 -enc=500a123456789012 -verbose
NOTE:On Linux systems, if the verbose argument is supplied, the
Logical Vols column is displayed listing the logical drive mapping of the physical disk drives. For these values to be discovered correctly, the following system items must be installed and configured: Device Mapper Multipath and Smartmontools.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\