For other management actions, you must provide information for a respective enclosure or EMM. These values are presented with respect to a specific adapter value provided.
To identify the attached enclosures to a specific adapter, run the following command:
shmcli list physical enclosures -a=<(SASAddress | AdapterIndex)>
The MD1400/MD1420/ME484 enclosures display the following output:
Figure 1. Command output example for MD1400/MD1420/ME484 enclosures
The MD2412/MD2424/MD2460 enclosures display the following output:
Figure 2. Command output example for MD2412/MD2424/MD2460 enclosures
NOTE:
In MD24 Series enclosures, a single enclosure is listed as two EMMs designated as side A and side B. Each pair of enclosure entries will have the same service tag number.
Check the Side column to identify the location of the EMM. The side A and side B represents slot 1 and slot 2 respectively.
Identifying EMMs
To identify the adapters attached to each EMM, run the following command:
shmcli list emms -a=<(SASAddress | AdapterIndex)>
The MD1400/MD1420/ME484 enclosures display the following output:
Figure 3. Command output example for MD1400/MD1420/ME484 enclosures
The MD2412/MD2424/MD2460 enclosures display the following output:
Figure 4. Command output example for MD2412/MD2424/MD2460 enclosures
Note the Enclosure Slot Index and the WWN columns. These values are required for command parameters.
Identifying drawers
Verify the status and number of drives in the drawers of an enclosure by running the following command:
shmcli list drawers -a=<(SASAddress | AdapterIndex)> -enc=<(WWN | EnclIndex)>
Figure 5. Command output example
Drawer 0 is the top drawer or the only drawer for the enclosure.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
