Update expansion module firmware
- Perform one of the following:
- In the banner, click the system panel and select Update Firmware.
- In the System topic, select Action > Update Firmware.
The Update Firmware panel opens. - Select the Update Expansion Modules tab. This tab shows information about each expansion module in the system.
- Select the expansion modules to update.
- Click File and select the firmware file to install.
- Click OK. Messages show firmware update progress.CAUTION:Do not perform a power cycle or controller restart during the firmware update. If the update is interrupted or there is a power failure, the module might become inoperative. If this occurs, contact technical support. The module might need to be returned to the factory for reprogramming.
It typically takes 3 minutes to update each EMP in an expansion enclosure. Wait for a message that the code load has completed.
- Verify that each updated expansion module has the new firmware version.