- Notes, cautions, and warnings
- Introduction
- Data protocols
- Dell EMC PowerVault MD Series storage array rules
- Default IPv4 settings for management ports on Dell EMC PowerVault MD series storage arrays
- RAID controller firmware and NVSRAM
- iSCSI software initiators
- Protocol (TOE/iSCSI) offload adapters
- Fibre Channel SFP+ Transceiver support
- Physical disks
- Expansion enclosures
- Management software
- Operating systems
- Windows ODX
- ALUA support on host operating systems
- Device mapper software
- SAS host bus adapters
- Fibre Channel host bus adapters
- Fibre Channel direct-attach configuration operating systems
- Required timeout settings for Fibre Channel host bus adapters
- Supported Fibre Channel switches
Dell EMC PowerVault MD34XX/38XX Series Support Matrix
Windows ODX
The MD34XX or MD38XX Series Storage Arrays support Windows ODX for Windows Server 2012 R2 or later.
NOTE: ODX is disabled by default and must be enabled using a SMcli command. For more information, refer to the Dell EMC PowerVault MD 34XX/38XX Series Storage Arrays CLI Guide at Dell.com/support.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\