- Notes, cautions, and warnings
- Additional Resources
- Introduction
- Power control procedures
- Safety precautions for handling replaceable units
- Support Notifications
Dell PowerStore Power Down and Reboot Procedures Guide
Reboot a node using a service script
Prerequisites
- Management IP address of the appliance that contains the node. In PowerStore Manager, go to . Review the Management IPs table to identify the management IP address associated with the appliance.
- Service account credentials
NOTE:Do not power off or reboot a node, if the peer node is not operating normally. If the peer node is experiencing any major issues, associated alerts and events appear in
PowerStore Manager.
Also, to avoid service interruptions, ensure that there are sufficient and healthy paths from all connected hosts to the peer node.
About this task
Steps
- Launch an SSH client, and connect to the appliance using the management IP address.
-
Enter the username and password for the service account to log in.
The login prompt indicates the node that you are logged into. For example, the letter "A" in the prompt [SVC:user@FNM12345678910-A~]$ indicates that you are logged into node A.
-
Based on the node you are logged into, run one of the following commands:
- svc_node reboot local to reboot the node you are logged into.
- svc_node reboot peer to reboot the peer node.
For more information, see the PowerStore Service Scripts Guide.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\