Dell PowerStore CLI User Guide
Display the header
You can display the header each time you run a switch or command. The header displays the destination system, system port number, the syntax, and communication protocol used (HTTPS).
The following example shows the header that is displayed after including the -header switch in a command:
pstcli -header volume show -o table PowerStore system: 10.55.34.87 Timezone: Eastern Daylight Time (UTC-03:00) User: admin 1: id = DNS1 addresses = 10.244.53.108, 10.244.53.109
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\