Dell PowerStore CLI User Guide
Access the system
To access and run commands on a system through PowerStore CLI, specify the network name or management IP address of the system, your username, and your password.
Format
[{-d|-destination} <value>] [{-u|-user} <user_name>] [{-p|-password} <password>]Switches
- -destination|-d
- IP address or network name of the destination system. If you do not include this switch, the client uses the addresses that are specified for -default. If no default address exists, the client uses the localhost address 127.0.0.1.
- -user|-u
- Username for logging in to the system. For example, admin.
- -password|-p
- Password for logging in to the system.
- -port
- Specify the port number through which to access the system.
NOTE:If you do not include the -port switch, PowerStore CLI accesses the system through default port 443.
- -default
- Save the destination, port pair, and SSL policy as defaults. You can use the -default switch with the -destination, -port, or -ssl_policy switches, or with any combination of those switches. The saved SSL policy applies to the client for all destinations. Also, you can update the destination and port separately. Save PowerStore CLI settings explains saving user account credentials to the local client system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\