You can map and unmap volumes to a single host or multiple hosts.
About this task
The following restrictions apply:
After a volume is mapped to a host, it shares the same storage protocol (SCSI or NVMe) as the host to which it is mapped.
Mixed protocols are not supported.
Steps
From
Storage > Volumes, check the box next to the volume or volumes that you want to map to a host.
Select
Provision > Map to open the
Map Hosts slide-out panel.
Select either
SCSI (Supports iSCSI or FC transport layer) or
NVMe (Supports NVMe FC transport layer) as the protocol that you want to use to map the volume or volumes.
Select any hosts or host groups that you want the volume to be mapped to.
Click
Apply.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\