Management IP address of the appliance that contains the node. In
PowerStore Manager, go to
Settings > Networking > Network IPs > Management. Review the
Management IPs table to identify the management IP address associated with the appliance.
Service account credentials
About this task
Use the following procedure to power on a node in scenarios such as:
You are remote and cannot reseat the node.
The node was not removed from the chassis.
The embedded module, I/O module, or 4-port card were replaced.
Steps
Launch an SSH client, and connect to the appliance using the management IP address. Since only the peer node is powered on, you are connected directly to the peer node of the appliance.
Enter the username and password that is associated with the service account, and log in.
Run the following command:
svc_node power_on
Wait for the node to power on.
NOTE:It may take several minutes for the node to power on.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\