Select the checkbox next to the name of the first port over which the storage traffic runs for the Storage network.
PowerStore Manager automatically maps the Storage network to both the port you selected, and the corresponding port on the other node.
To validate the Storage network was successfully configured:
Go to the
Hardware page.
Select the appliance name and go to the
Ports page.
Locate the port on which you created the Storage network in the
Node-Module-Name column.
The
Link State should be green, and the Storage network should appear in the
Mapped for Storage column.
Locate the corresponding port on the other appliance node, to validate that the
Link State is green, and the Storage network appears in the
Mapped for Storage column.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\