- Notes, cautions, and warnings
- Additional Resources
- Overview
- Storage services overview
- Prepare to configure the switches and networks for Storage services
- Switch requirements for deployments with storage services
- Network requirements for deployments with storage services
- Configuring PowerStore storage networks with Dell PowerSwitch Series S4148 Top-of-Rack switches
- Sample configuration
- Install the Top-of-Rack switches into the cabinet with the PowerStore appliance
- Configure Dell PowerSwitch Series for Storage services
- Get the completed Switch resources for Storage services worksheet
- Establish a terminal session to the switch
- Validate the switch version and licensing
- Configure general settings on the Top-of-Rack (ToR) switches
- Configure Virtual Link Trunking interconnect
- Configure the uplink ports on the Top-of-Rack (ToR) switches
- Configure the iSCSI network on the ToR switches
- Configure NVMe/TCP network on the ToR switches
- Configure the Replication and Block Import network on the ToR switches
- Configure NAS networks on the ToR switches
- Configure Cluster network on the Top-of-Rack switches
- Cable Dell PowerSwitch Series ToR switches for Storage services
- Validate PowerSwitch Series configuration with ToR switches
- Configure Storage networks in PowerStore Manager
- Create an additional Storage network
- Expand a Storage network to run across multiple ports
- Configuring a Fail-Safe Network with Dell PowerSwitch Series S4148 Top-of-Rack switches
- Sample Configuration
- Configure the Dell PowerSwitch Series to extend the NAS network with a Fail-Safe Network
- Get the completed worksheet for Switch resources to extend the NAS network with a Fail-Safe Network
- Cable the switches for the Fail-Safe Network
- Establish a terminal session to the switch
- Configure the Fail-Safe Network on the switch
- Validate NAS with FSN configuration on the Top-of-Rack (ToR) switches
- Create the Fail-Safe Network in PowerStore Manager
- File Mobility
- Configuring PowerStore T model appliances with ToR switches without a VLT interconnect
- Other Dell PowerSwitch Series configuration operations
Dell PowerStore PowerStore T and Q Networking Guide for Storage Services
Cable the nodes to the ToR switches
The following steps provide an example of cabling the PowerStore T model appliance nodes to two Dell PowerSwitch Series S4148 Top-of-Rack (ToR) switches.
The following instructions apply to the iSCSI storage network, and the ToR switches configured in Configuring PowerStore storage networks with Dell PowerSwitch Series S4148 Top-of-Rack switches .
The following example uses port 1 on I/O Module 0. However, use any available port on any I/O module if your nodes have been configured with I/O modules.
NOTE:Ports 0 and 1 of the 4-port card are reserved for the cluster network with all
PowerStore T model appliances. Ports 2 and 3 of the 4-port card in PowerStore 500T model appliances are reserved for connectivity to the 24 Drive 2.5-Inch NVMe (ENS24) expansion enclosures.
As demonstrated below, when cabling the nodes to the ToR switches the bottom node (A), and the top node (B) must be cabled to opposite switches.
- Connect Port 1 in I/O Module 0 of the bottom Node A to Port 6 of the bottom switch (Switch1).
- Connect Port 1 in I/O Module 0 of the top Node B, to Port 49 of the top switch (Switch2).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\