PowerStore appliance storage networks can be configured over different ports, VLANs, or subnets.
PowerStore appliances require all networks are unique. It is highly recommended to deploy PowerStore networks with multiple and unique VLANs to separate the traffic. However, if only one VLAN is available, you can deploy PowerStore appliances with a single VLAN and multiple unique subnets.
VLAN requirements
You can add up to 256 Storage networks with a maximum of 256 storage networks per interface.
For better security and performance, it is recommended that you specify a unique VLAN ID for each type of network.
If you are deploying into a single VLAN, ensure that you configure a unique subnet for each of the Storage networks.
When configuring the networks in
PowerStore Manager, be sure to use the same VLAN IDs that were used to configure your networks on the switch.
Cluster network VLAN requirements
The Cluster network communication occurs on the Native VLAN.
For multi-appliance cluster configurations, ensure that the Cluster network has routing on the native VLAN such that the first 2 ports of the 4-port card can communicate to other appliances on the network.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\