Add IP addresses and map the Storage network to the ports
Once the Top-of-Rack (ToR) switches are configured and cabled to expand the storage network, you must add IP addresses, and map the ports for expansion in
PowerStore Manager.
Network resources required to expand a storage network
Sample values are used in the following steps.
From
PowerStore Manager go to
Settings > Networking > Network IPs and select the
Storage tab.
Select the checkbox next to the name of the Storage network that you are expanding.
Select
Add IPs.
Select
Add in the
IP Addresses for <storage network name> page.
Enter the IP addresses or address range for the addresses that are reserved for expanding the storage network and Select
Add.
Go to the
Hardware page.
Select the appliance name and go to the
Ports tab.
Select the checkbox next to the name of one of the ports on which you are expanding the Storage network.
Select
Map Storage Network.
Select the checkbox next to the Storage network that you are expanding on the
Map Storage Network page, and Select
Map Network.
PowerStore Manager automatically maps the unused IP addresses that you added in Step 5.
Select
Map Network again in the
Map Storage Network
confirmation dialog box.
PowerStore Manager automatically maps the Storage network to both the port that you selected, and the corresponding port on the other node.
To validate the Storage network was successfully configured:
Locate the port on which you expanded the Storage network in the
Node-Module-Name column.
The
Link State should be green, and the Storage network should appear in the
Mapped for Storage column.
Locate the corresponding port on the other appliance node, to validate that the
Link State is green, and the Storage network appears in the
Mapped for Storage column.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\