- Notes, cautions, and warnings
- Additional Resources
- Platform overview
- Base enclosure component descriptions
- 24 Drive 2.5 Inch NVMe expansion enclosure (ENS24) component descriptions
- Technical specifications
Each NVMe expansion enclosure contains two LCCs, and each LCC contains an Access Module and a Drive Interface Board that is located behind the Access Module. The Drive Interface Board connects the front-end to the back-end and contains the PCIe switches that connect the drives and the Access Module.
The Access Module manages and reports the environmental conditions of the NVMe expansion enclosure such as power, thermal, status indicators, and component presence. The Access Module employs NVMe-oF (NVMe over Fabrics) technology by using RDMA over Converged Ethernet (RoCE) for Ethernet. This technology allows the Access Module to perform the translation of the persistent storage data received over the Ethernet interfaces and transfer it onto the PCIe connections of the NVMe drives. The Access Module also applies the data protection that is deployed by the system.
The Access Module contains the following components:
The following figure shows the location of these components:
Location | Description |
---|---|
1 | 100GbE ports (QSFP28) |
2 | Micro USB port (not used) |
3 | USB port (not used) |
4 | 1GbE RJ45 management ports (for support only) |
LED | Location | State | Description |
---|---|---|---|
Power status | 1 | Green | Power on. |
Off | Power off. | ||
Fault status | 2 | Amber | Faulted hardware. |
Off | No fault has occurred. Normal operation. | ||
System ID | 3 | Blinking blue | System ID mode is enabled. |
Off | System ID mode is not enabled. | ||
Daisy chain ID | 4 | 50–52 | Identifies where in the daisy chain the expansion enclosure is located:
|