- Notes, cautions, and warnings
- Additional Resources
- Introduction
- Remote Systems
- Snapshots
- Protection Policies
- Replication
- Asynchronous replication
- Synchronous replication
- Pause a replication session
- Resume a replication session
- Failover
- Other considerations for replication
- Testing disaster recovery for NAS servers under replication
- Virtual volumes replication
- Metro Protection
- Pre-requisites and limitations
- Configure host connectivity
- Metro witness
- Configure a metro volume
- Configure a metro volume group
- Set the metro role
- Monitor metro resources
- Pause a metro resource
- Resume a metro resource
- Promote a metro resource
- Demote a metro resource
- End a metro resource
- Summary of allowed actions on a metro resource
- Using protection policies with metro
- Using QoS with metro
- Remote Backup
- NDMP Backup for NAS Servers
- Replication summary
- Use cases
Dell PowerStore Protecting Your Data
Remote backup alerts
The Alerts tab (located under Monitoring) displays general alerts that are generated for remote backup sessions, such as session creation and completion, adding or removing a remote system, and so on. You can filter remote backup alerts by selecting Remote Session and Remote System as Resource Type.
Alerts are also issued when failures occur. The number of alerts is displayed in the Backup Sessions and Retrieve Sessions tabs. Clicking the number opens the Alerts tab.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\