When you retrieve a remote snapshot to a
PowerStore cluster other than the cluster that has the source resource, a new volume or volume group is created on the
PowerStore cluster, as well as a local snapshot to which the remote snapshot is copied.
Steps
Click
Protection > Remote Backup and select the
Resources tab.
Click
Discover Remote Snapshots.
In the
Discover Remote Snapshots panel, set the following:
PowerProtect DD Remote System—Select the PowerProtect DD from which you want to retrieve the backup.
PowerStore Global ID—Specify the global unique identifier for the
PowerStore cluster from which the backup was initiated. You can see the global ID of the cluster under
Settings
> Cluster > Properties.
From—Specify the starting date and time to search for remote snapshots.
To—Specify the ending date and time to search for remote snapshots.
Click
Next.
From the list of discovered snapshot, select the snapshot that you want to retrieve, and click
Next.
NOTE:You can only select snapshots that were created by a
PowerStore cluster.
Review the information summary and click
Retrieve.
Results
PowerStore creates a retrieve session that can be viewed on the
Retrieve sessions tab. When the session is complete, the retrieved snapshot and a new volume are created on the local cluster.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\