If the pre-requirements are met, you can use RPM to directly install the witness. Otherwise, you can use a package manager (yum, zypper) to automatically install the dependencies. You can download the installation package from the
Dell Support page.
To install the witness service on a Linux host, run the following command:
sudo rpm -i <rpm_file>
NOTE:You can use a package manager or RPM to uninstall the witness.
NOTE:Witness is not supported with HCI deployments of
PowerStore.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\