Add a remote system connection for replication and metro
Configure a remote system connection between the source and destination
PowerStore systems to enable synchronous and asynchronous replication, and metro protection.
Prerequisites
Before creating a remote system connection, ensure that you have obtained the following remote system details:
System IP address
User authentication credentials for connecting to the system
Steps
Select
Protection > Remote Systems.
In the
Remote Systems window, click
Add.
In the
Add Remote System slide-out panel, configure the following fields:
Remote system type - Select
PowerStore.
Management IP address
Description (optional)
Network latency
NOTE:If the remote system is used for metro or synchronous replication, the network latency must be set to Low.
Username and password
Click
Add.
In the
User Authorization panel, verify the remote system certificate and click
Confirm.
Results
The new remote system connection is added to the
Remote Systems table. You can hover over the
Capability column to view the replication capabilities for the new connection.
NOTE:The displayed capabilities are derived from the settings that were configured for the remote system.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\