Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerStore Installation and Service Guide for PowerStore 1000, 1200, 3000, 3200, 5000, 5200, 7000, 9000, and 9200

PDF

Removing a faulted LCC

Prerequisites

Identify the faulted LCC by it amber fault LED.

Figure 1. LCC fault LED
LCC fault LED

About this task

CAUTION:The DAE must have at least one LCC installed while the enclosure is powered up; do not remove both LCCs while AC power is on.

Steps

  1. Attach an ESD wristband to your wrist and the enclosure.
  2. Remove each cable connected to the LCC by gently pulling the connector latches to release the cable from the connector.

    Note where the cables connect to the LCC because you will reconnect them later.

    Figure 2. Disconnecting an LCC cable
    Disconnecting an LCC cable.
  3. Remove the LCC:
    CAUTION:The LCC comes completely out of the DAE chassis. In addition to holding the latches, be prepared to support the LCC to avoid dropping it.
    1. Locate the orange handle buttons on the LCC handles.
    2. Press the orange handle buttons to release the LCC, pull the latches outward, and remove the LCC from its slot.
      Figure 3. Removing an LCC
      Removing an LCC.
  4. Place the LCC on a clean, static-free surface.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\