Dell VNX2 and
Dell Unity port requirements for file-based data import
To import file-based data from a Dell VNX2 system to a
PowerStore cluster,
PowerStore should be able to access the following ports on the
Dell VNX2 system:
To establish import connections: ports 22, 2022, 443 (for block import only), and 5989 (for block import only)
For NFS VDM import: ports 111, 1234, and 2049
For SMB (CIFS) VDM import: port 445
For FLR-enabled file system import: port 5080
NOTE:On the
Dell VNX2 source system, the physical Data Mover that is configured with the DHSM service can be set to a different port than the default port 5080. This port must match on both
Dell VNX2 and
PowerStore in order for the import of FLR-enabled file systems to succeed. To import FLR-enabled file systems, if the source
Dell VNX2 Data Mover is not using the default port, If possible, change the
Dell VNX2 Data Mover that is configured with the DHSM service to use the default port 5080 before creating the file import.
NOTE:ICMP or ICMPv6 pings must be allowed.
For more information related to ports on the
Dell VNX2 system, refer to the
EMC VNX Series Security Configuration Guide for VNX.
To import file-based data from a
Dell Unity system to a
PowerStore cluster,
PowerStore should be able to access the following ports on the
Dell Unity system:
To establish import connections: ports 22, 443
For NFS VDM import: ports 111, 1234, and 2049
For SMB (CIFS) VDM import: port 445
For FLR-enabled file system import: port 5080
NOTE:ICMP or ICMPv6 pings must be allowed.
For more information related to ports on the
Dell Unity system, refer to the
Dell Unity Family Security Configuration Guide.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\