Configure a File Mobility Network for file-based import
About this task
A file mobility network is a prerequisite infrastructure that is needed for the exchange of control traffic between NAS clusters in a file import environment. The configuration consists of the following IP addresses:
A file mobility cluster IP address for the
PowerStore appliance
A file mobility IP address for Node A of the
PowerStore appliance
A file mobility IP address for Node B of the
PowerStore appliance
Once the file mobility network is created, its IP addresses must be mapped to the
PowerStore management interface. To configure a file mobility network for file-based import, do the following:
NOTE:For general information about file mobility network, see the
PowerStore Manager online help. For detailed information about configuring a file mobility network, see the
PowerStore T and Q Networking Guide for Storage Services
.
Steps
In
PowerStore Manager, select
Settings and under
Networking select
Network IPs.
The
Network IPs page appears.
Select the
File Mobility tab.
Select
Create.
The
Create File Mobility Network slide out panel appears.
Specify the relevant information to create the file mobility network and then click
Create.
The File Mobility Cluster is created.
Select
Map Network to map the file mobility network to the
PowerStore management interface.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\