- Notes, cautions, and warnings
- Additional Resources
- Volumes
- Volume groups overview
- Hosts and host group configurations
- Data mobility for volumes and volume groups
- Thin clones
- Quality of Service (QoS) policies
- Performance policies
Dell PowerStore Configuring Volumes
Map volumes to a host or a host group
You can map volumes to a single host or to a host group.
About this task
- After a volume is mapped to a host, it shares the same storage protocol (SCSI or NVMe) as the host to which it is mapped.
- Mixed protocols are not supported.
Steps
- From , check the box next to the host or host group to which you want to map volumes.
- Select to open the Map Volumes slide-out panel.
- Select one or more volumes that you want to be mapped to the host or host group.
- Select whether to provide a Logical Unit Number or have one generated automatically.
- Click Apply.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\