- Notes, cautions, and warnings
- Revision history
- Introduction
- Revision history
- Getting started
- Monitoring system health
- Managing system resources in services
- Discovering resources
- Managing credentials
- Managing compliance
- Updating PowerFlex Manager and components
- Expanding a system
- Managing the PowerFlex Manager virtual appliance
- Troubleshooting and support
Dell EMC PowerFlex Rack Using PowerFlex Manager
Expanding a system
You can expand a system with additional PowerFlex nodes. You do this in PowerFlex Manager by adding nodes to a service.
The following are the high-level expansion tasks, if PowerFlex Manager was installed and configured in the factory:
- Discover and configure the PowerFlex node for alerting.
- Ensure the availability of network IP addresses.
- Add PowerFlex nodes to a service.
If your system did not have PowerFlex Manager installed and configured in the factory, and you are expanding a service that was initially deployed outside of PowerFlex Manager, you must complete the following expansion steps:
- Discover and configure the PowerFlex node for alerting.
- Add a network to a service deployed outside of PowerFlex Manager.
- Ensure the availability of network IP addresses.
- Add PowerFlex nodes to a service.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\