- Notes, cautions, and warnings
- Revision history
- Introduction
- Revision history
- Getting started
- Monitoring system health
- Managing system resources in services
- Discovering resources
- Managing credentials
- Managing compliance
- Updating PowerFlex Manager and components
- Expanding a system
- Managing the PowerFlex Manager virtual appliance
- Troubleshooting and support
Dell EMC PowerFlex Rack Using PowerFlex Manager
Adding volumes
This section describes how to create new volumes or add existing volumes to a service.
You can create new volumes for PowerFlex storage-only or hyperconverged nodes. You can create up to 50 new volumes at a time for these nodes.
You can add existing volumes to PowerFlex compute-only or hyperconverged nodes.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\