Dell PowerFlex Appliance with PowerFlex 3.x Administration Guide

Manual install using USB

A USB device can be used to manually upgrade OS10.

1. Use the output of the following command to copy/paste the .BIN filename into the install command below.

   ONIE:/ # ls /mnt/usb

2. Change to the USB directory.

    ONIE:/ # cd /mnt/usb

3. Manually install using the onie-nos-install command. If installing version 10.x.x, the command is:

   ONIE:/mnt/usb # onie-nos-install PKGS_OS10-Enterprise-10.x.x-installer-x86_64.bin

   The OS10 update takes approximately 10 minutes to complete and boots to the OS10 login: prompt when done. Several messages display during the installation process.
4. Log in to OS10 and run the show version command to verify that the update was successful.

   OS10# show version
   Dell EMC Networking OS10 Enterprise
   Copyright (c) 1999-2018 by Dell Inc. All Rights Reserved.
   OS Version: 10.x.x
   Build Version: 10.x.x
   Build Time: 2018-03-30T18:05:41-0700
   System Type: S4148F-ON
   Architecture: x86_64
   Up Time: 00:02:14