Dell PowerFlex Appliance with PowerFlex 3.x Administration Guide

PDF

Add a VLAN to an access switch connected to a PowerFlex appliance cluster

Configure an access switch that is connected to a PowerFlex appliance cluster.

About this task

The following commands are an example of how to add VLAN 10 to the uplink port channel 100. You must perform these commands on both access switches.

Steps

On the command prompt, type the following:

Switch type

Command

Dell PowerSwitch

Dell#configure
Dell(conf)#interface vlan<vlan id>
Dell(config-vlan)#no shutdown
Dell#copy running-config startup-config

Cisco Nexus

Cisco_Access-A# configure 
Cisco_Access-A(config)# vlan 10 
Cisco_Access-A(config-vlan)# exit
Cisco_Access-A(config)# interface port-channel 100 
Cisco_Access-A(config-if)# switchport trunk allowed vlan add 10
Cisco_Access-A(config-if)# end
Cisco_Access-A# copy running-config startup-config