CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the slots on the hard drive backplane
with the hooks on the chassis.
Slide down the hard drive backplane until the
release pins align with the slots on the chassis and click into place.
Connect the power cables to the hard drive
backplane.
Route the power cables along the chassis base.
If applicable, connect the power and data cable
to the optical drive.
Reinstall the backplane expander board.
Reinstall the cooling fan assembly.
Reinstall the cooling shroud.
Install the hard drives in their original
locations.
Close the system.
If applicable, place the system upright and
on its feet on a flat, stable surface.
If removed, reinstall the hard drives, server
modules, and power supply units.
Reconnect the enclosure to its electrical
outlet and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\