CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the following:
the two metal standoffs on one side of
the PCIe cage, toward the PCIe cage door, with the bracket on the
chassis side.
the expansion card riser connectors with
the connectors on the system board.
the slot on the expansion card riser with
the guide pin on the system board.
Slide the PCIe cage into the chassis, until
firmly seated.
When firmly seated, the slots on the PCIe
cage align with the metal tabs on the chassis.
Tighten the two screws to secure the PCIe
cage to the chassis.
Rotate the release latch to lock position,
to secure the PCIe cage to the chassis.
Reinstall the expansion cards, if applicable,
or the filler brackets.
Reinstall the cooling fan assembly.
Reinstall the cooling shroud.
Close the PCIe cage door.
Close the system.
If applicable, place the system upright on
a flat, stable surface and rotate the system feet outward.
If removed, reinstall the hard drives, server
modules, and power supply units.
Reconnect the enclosure to its electrical
outlet and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\